The SUD error on your Whirlpool Washer means the machine has detected excessive suds in the drum. The washer will pause the cycle and wait for the suds to dissipate before continuing, which can significantly extend wash time.
| Error code | SUD (or SD) |
|---|---|
| Meaning | Excessive suds detected in the wash drum |
| Severity | Low — Usually resolves on its own but may indicate an underlying issue |
| Time to fix | 5–30 minutes (plus wait time for suds to clear) |
| Tools needed | None |
What the SUD error means
The SUD error (sometimes displayed as SD) indicates your Whirlpool washer has detected too many soap suds during the wash cycle. Modern high-efficiency (HE) washers use less water than traditional models and require low-sudsing detergent to function properly. When excessive suds are detected, the machine’s sensors trigger this error code and the washer pauses to allow the foam to dissipate naturally, which can add 20 minutes or more to your cycle.
Common causes
- Using regular detergent instead of HE (high-efficiency) detergent
- Using too much detergent, even if it’s HE formula
- Using liquid fabric softener directly in the drum
- Washing heavily soiled items that retain detergent residue from previous washes
- Clogged drain pump or drain hose causing slow water drainage
- Water pressure issues preventing proper rinse cycles
How to fix the SUD error
- Let the washer complete its suds reduction cycle: Don’t interrupt the machine. It will automatically pause and wait for suds to break down, then attempt to drain and continue. This may take 10–30 minutes but usually resolves the error.
- Run a rinse and spin cycle: If the SUD error persists or the cycle completes with sudsy clothes, run an extra rinse and spin cycle without adding any detergent to remove remaining suds from your laundry.
- Switch to HE detergent and reduce the amount: Use only HE (high-efficiency) detergent formulated for front-load and high-efficiency top-load washers. Start with half the recommended amount on the bottle—most people use too much detergent. Two tablespoons is typically sufficient for a full load.
- Clean the drain pump filter: Locate the drain pump filter (usually behind a small door at the front bottom of the washer). Place towels underneath, open the filter cap slowly to drain residual water, and remove any debris or buildup that could restrict drainage.
- Check and clean the drain hose: Ensure the drain hose isn’t kinked or clogged. Disconnect it from the standpipe or drain, check for obstructions, and flush it with water if necessary. Poor drainage can cause suds to accumulate.
- Run a cleaning cycle: Use the washer’s “Clean Washer” cycle with a washing machine cleaner or white vinegar (no detergent) to remove detergent buildup from the drum, hoses, and pump system. This helps prevent future SUD errors.
FAQ
Can I use regular detergent in my Whirlpool high-efficiency washer?
No, you should only use HE (high-efficiency) detergent in HE washers. Regular detergent creates excessive suds that HE washers cannot rinse away properly with their lower water usage, leading to SUD errors, poor cleaning, and potential long-term damage to the machine.
How much detergent should I actually use in my Whirlpool washer?
Use about 2 tablespoons (1 ounce) of HE liquid detergent for a regular load, even less for soft water or lightly soiled clothes. Detergent manufacturers often recommend more than necessary. Start with less—you can always add more if cleaning isn’t adequate, but too much causes suds problems and doesn’t clean better.
Why does the SUD error keep coming back even when I use less detergent?
Recurring SUD errors despite proper detergent use usually indicate a drainage problem. Check for a clogged drain pump filter, kinked drain hose, or slow-draining standpipe. Detergent buildup in the washer drum and internal hoses from previous overuse can also cause repeated errors—run several cleaning cycles with no detergent to flush the system.