The F8 error on your Maytag Washer means the control board has detected a water fill problem, usually that the tub is taking too long to fill or isn’t filling at all. This is often shown as F8 E1 on digital display models. Checking your water supply and inlet filters usually solves it.

Error code F8
Meaning Long fill or no-fill error — the washer isn’t reaching the correct water level within the expected time
Severity Medium — the washer will pause the cycle but this is easy to fix yourself in most cases
Time to fix 10–30 minutes
Tools needed Pliers, towel (None if only resetting or checking taps)

What the F8 error means

Maytag washers use a water level pressure switch to monitor how quickly the tub fills. If it doesn’t detect enough water within a set time frame (often around 8-10 minutes), the control board triggers the F8 error and stops the cycle. This is a protective measure to stop the machine running with too little water rather than a sign of major damage.

Common causes

  • Household water supply valves to the washer are partly closed or turned off
  • Low household water pressure feeding the machine
  • Clogged inlet screens/filters where the hoses connect to the washer
  • Kinked, twisted, or damaged water inlet hoses
  • Faulty water inlet valve that isn’t opening fully
  • Failed water level pressure switch or blocked pressure hose

How to fix the F8 error

  1. Check the water taps: Make sure both hot and cold water supply valves behind the washer are fully open.
  2. Inspect the hoses: Look for kinks, tight bends, or cracks in the inlet hoses and straighten or replace as needed.
  3. Clean the inlet filters: Turn off the water, disconnect the hoses at the back of the washer, and use pliers to remove and rinse the small mesh filters where the hoses attach.
  4. Test water pressure: Run a tap elsewhere in the house to confirm normal water pressure; low pressure from your supply can trigger this error.
  5. Power cycle the washer: Unplug it for 60 seconds, then plug it back in and start a new cycle to see if the error clears.
  6. Call a technician: If the error persists after these checks, the water inlet valve or pressure switch may need professional replacement.

FAQ

Can I still use my washer if it shows F8?
No, the cycle will pause until the fill issue is resolved, so it’s best to fix the cause before running another load.

Is F8 the same as F8 E1 or F8 E2?
F8 E1 usually means a long fill time, while F8 E2 can indicate an overfill issue; both relate to water flow but have slightly different causes.

Will resetting the washer fix the F8 error permanently?
A reset can clear the error temporarily, but if the underlying cause like a clogged filter or faulty valve isn’t fixed, the code will likely return.

If you’re troubleshooting other codes, you may also find these guides useful: Maytag Washer F1 Error Code: Causes and Fixes, Maytag Washer F2 Error Code: Causes and Fixes, Maytag Washer F3 Error Code: Causes and Fixes, and Maytag Washer F5 Error Code: Causes and Fixes.