The E2 error on your Maytag Washer means the control board has detected a keypad or user interface communication fault. In most cases power-cycling the machine and checking the wiring connections between the control board and keypad will clear it.

Error code E2
Meaning Keypad or touchpad communication error between the user interface and main control board
Severity Medium — the washer may still run but buttons can become unresponsive
Time to fix 10–30 minutes
Tools needed Phillips screwdriver, multimeter (optional)

What the E2 error means

E2 shows up when the washer’s main control board can’t properly communicate with the keypad or user interface panel. This is usually a signal or connection issue rather than a mechanical fault, so the drum and motor are often unaffected. It’s similar in nature to other communication faults like the Maytag Washer F1 Error Code, which also points to a control board problem.

Common causes

  • Loose or corroded ribbon cable connecting the keypad to the control board
  • A temporary software glitch after a power surge or outage
  • Failing user interface (touchpad) board
  • Faulty main control board
  • Moisture or spilled detergent affecting the keypad connector
  • Worn-out button contacts on the touchpad

How to fix the E2 error

  1. Power cycle the washer: Unplug it for 60 seconds, then plug it back in to reset the control board and clear a temporary glitch.
  2. Inspect the keypad wiring: Unplug the machine, remove the control panel, and check the ribbon cable and connectors for looseness, corrosion, or damage.
  3. Reseat all connections: Disconnect and firmly reconnect the cable between the user interface and the main control board.
  4. Clean the connector contacts: Use a dry cloth or electronics-safe contact cleaner to remove any moisture or residue on the connector pins.
  5. Test the touchpad: If buttons still don’t respond after reconnecting, the touchpad itself may be faulty and need replacing.
  6. Replace the control board: If the error persists after checking wiring and the touchpad, the main control board is likely the cause and should be replaced.

FAQ

Can I still use my washer with an E2 error showing?
Sometimes, if the buttons still respond intermittently, but it’s best to fix the issue before it fully locks up the controls.

Will unplugging the washer damage anything?
No, unplugging and power cycling is a safe first troubleshooting step and won’t harm the machine.

Is E2 related to other Maytag error codes like F2 or F3?
Not directly, but it shares the same category of control board communication issues seen in the Maytag Washer F2 Error Code and Maytag Washer F3 Error Code guides.