The F06 error on your Indesit Dryer means the control board has lost communication with the motor or the motor’s speed sensor (tacho). Fix hint: this usually points to a wiring fault, a worn motor, or a stuck drum, and often needs a multimeter to trace the problem.

Error code F06
Meaning Motor circuit or tacho signal fault — the control board can’t read the motor’s speed correctly
Severity High — the dryer will not run a cycle until this is fixed
Time to fix 20–60 minutes
Tools needed Multimeter, screwdriver set, torch

What the F06 error means

Indesit dryers use a tacho sensor to monitor drum motor speed and report it back to the control board. When the board doesn’t receive a proper signal — either because the motor has stopped turning, the sensor has failed, or a wire has come loose — it triggers the F06 code and halts the cycle to prevent damage.

This is similar in concept to motor-related faults on Indesit washing machines, such as the Indesit Washing F04 Error Code: Causes and Fixes, where the control board also loses track of a key moving part.

Common causes

  • Worn or damaged carbon brushes in the motor
  • Loose or corroded wiring connector at the motor or tacho sensor
  • Faulty tacho sensor no longer sending a signal
  • Drum belt slipped off, stopping the motor from turning freely
  • Drum jammed or obstructed by an item of clothing or foreign object
  • Failing motor that needs replacing

How to fix the F06 error

  1. Unplug the dryer: Always disconnect power before opening any panels to avoid electric shock.
  2. Check the drum turns freely: Open the door and try to rotate the drum by hand. If it’s stiff or jammed, remove any obstruction and check the belt hasn’t slipped.
  3. Inspect the belt: Remove the back panel and check the drum belt is intact and correctly seated around the motor pulley and drum.
  4. Test the motor and tacho wiring: With the multimeter, check continuity on the motor windings and tacho sensor wiring. Look for loose connectors and corrosion.
  5. Check the carbon brushes: If your model has brushed motors, inspect them for wear — brushes shorter than 5mm typically need replacing.
  6. Replace the motor if needed: If wiring and belt are fine but the fault persists, the motor or tacho sensor likely needs replacing — this is best done by a qualified technician.

FAQ

Can I reset the F06 error myself?
Sometimes unplugging the dryer for a few minutes and checking the drum turns freely clears a temporary fault, but if it returns, there’s a hardware issue that needs inspecting.

Is it safe to keep using the dryer with an F06 error?
No. The dryer will likely stop mid-cycle or refuse to start, and continuing to force it risks damaging the motor further.

How much does it cost to fix an F06 error?
A loose wire fix costs nothing beyond your time, but a replacement motor or tacho sensor typically costs £50–£150 plus labour if you use an engineer.