Ge Washing TS Error Code: Causes and Fixes

The TS error on your Ge Washing means the machine has detected a problem with its water temperature sensor. This usually stops the wash cycle partway through until the fault is cleared, so it’s worth checking the sensor and wiring before running another load.

What the TS error means

Your GE washing machine uses a temperature sensor to monitor the water going into the drum, making sure it matches the wash cycle you’ve selected. The TS code appears when the control board either can’t get a reading from this sensor, or the reading it gets is outside the expected range.

This can happen because of a genuine sensor failure, a loose or corroded wire connection, or occasionally a control board issue. It’s similar in nature to sensor-related faults on other machines, such as the Ge Washing IE Error Code, which also relates to water detection problems.

Common causes

• Faulty temperature sensor (thermistor) that needs replacing
• Loose, corroded, or disconnected wiring at the sensor connector
• Water inlet valve supplying water at an unusual temperature
• Control board failing to read sensor input correctly
• Sensor wire harness damaged by rubbing against the drum or frame
• Recent power surge or electrical fault affecting the board

How to fix the TS error

1. Power cycle the machine — Unplug the washer for 5 minutes, then plug it back in. This clears temporary faults and resets the control board.
2. Check the water supply temperature — Make sure both hot and cold supply valves are turned on fully and the water reaching the machine isn’t unusually hot or cold, as extreme temperatures can trigger a false reading.
3. Inspect the sensor wiring — Unplug the washer, remove the back or top panel, and check the connector at the temperature sensor for corrosion, looseness, or damage. Reseat the connector firmly.
4. Test the sensor with a multimeter — With the washer unplugged, disconnect the sensor and check its resistance against the manufacturer’s spec. A reading well outside range means the sensor needs replacing.
5. Replace the temperature sensor — If testing confirms a fault, fit a new GE-approved sensor. This is a straightforward swap once you’ve located the part behind the tub.
6. Call a qualified technician — If the sensor and wiring test fine but the TS code keeps returning, the control board itself may be at fault and should be checked by a professional.

FAQ

Can I still run a wash cycle with the TS error showing?
It’s best not to. The machine may not heat water correctly, which can affect wash quality and, in some cases, cause the cycle to stop partway through.

Is the TS error the same as other GE sensor codes like OE or UE?
No. TS relates specifically to temperature sensing, whereas codes like the Ge Washing OE Error Code relate to drainage, and the Ge Washing UE Error Code relates to load balance.

Do I need a professional to fix a TS error?
Not always. If it’s a loose connector or wiring issue, most homeowners can fix it themselves. Sensor or control board replacement is also manageable with basic tools, but call an appliance technician if you’re unsure.