The E11 error on your Frigidaire washing machine means the unit isn’t detecting water filling fast enough or at all. This is almost always related to water supply or the fill system, and it’s usually a quick fix you can handle yourself before calling for service.

Error code E11
Meaning Long fill time or no water detected entering the tub within the expected time
Severity Low — usually a supply or valve issue, not a control board failure
Time to fix 10–30 minutes
Tools needed None (occasionally pliers for hose connections)

What the E11 error means

Frigidaire washing machines monitor how long it takes to fill the tub with water. If the machine doesn’t sense enough water flowing in within a set time window, it stops the cycle and displays E11. This protects the machine from running a wash cycle without proper water levels, which could damage the motor or leave clothes unwashed.

In most cases the problem sits outside the machine — in your home’s water supply, the inlet hoses, or the filter screens where hoses connect to the machine. Less often, the water inlet valve itself has failed.

Common causes

  • Water supply valves (hot/cold taps behind the machine) not fully open
  • Kinked, twisted, or crushed water inlet hoses
  • Clogged inlet filter screens where hoses connect to the machine
  • Low household water pressure
  • Faulty or stuck water inlet valve
  • Water supply temporarily shut off (e.g., during plumbing work)

How to fix the E11 error

  1. Check the water taps. Make sure both hot and cold water valves behind the washer are fully open. A partially closed valve is one of the most common causes of this error.
  2. Inspect the hoses for kinks. Pull the washer out slightly and check that both inlet hoses aren’t bent, twisted, or pinched behind the unit.
  3. Clean the inlet filter screens. Turn off the water supply, disconnect the hoses at the back of the machine, and check the small mesh filters inside the connection ports. Rinse away any sediment or debris under running water.
  4. Test your water pressure. Frigidaire washers need a minimum water pressure to fill properly. If other taps in the house also run weak, the issue may be a household plumbing problem rather than the washer.
  5. Reconnect and run a test cycle. Reattach the hoses securely, turn the water supply back on, and start a short cycle to see if the error clears.
  6. Call a technician if it persists. If water flow at the taps and hoses is fine but the error keeps appearing, the water inlet valve inside the machine may need replacing.

FAQ

Can I still use my washer if it shows E11?
No, the cycle will stop until the water fill issue is resolved. Clear the error before running another load.

Does E11 mean the water inlet valve is broken?
Not necessarily. Most cases are caused by closed taps, kinked hoses, or clogged filters. A faulty valve is possible but less common.

How do I clear the E11 code after fixing the issue?
Unplug the washer for one minute, plug it back in, and start a new cycle. The code should not reappear if the water flow issue is resolved.