The F13 error on your Frigidaire means the oven control board has detected a fault with the touch pad or keypad ribbon connection, usually caused by a stuck button or a bad connection between the keypad and control board. Turning off power to the oven for a few minutes often clears it, but a stuck key or damaged ribbon will need attention.

Error code F13
Meaning Touch pad/keypad shorted or stuck button detected by the control board
Severity Medium — oven may still work but touch pad functions can be unreliable or locked out
Time to fix 10–45 minutes
Tools needed Screwdriver (Phillips/flathead), soft cloth, multimeter (optional)

What the F13 error means

F13 shows up when the oven’s electronic control board senses that a key on the touch pad has been pressed continuously for too long, or that the ribbon cable connecting the touch pad to the control board has a short or a poor connection. This is a control-panel-side fault rather than a heating or temperature sensor issue.

The error is similar in nature to keypad and communication faults seen on other appliances, such as those covered in Frigidaire EF Error Code: Causes and Fixes, where a component reports a fault back to the main control board.

Common causes

  • A physical button on the touch pad is stuck or has debris/spills trapped underneath it
  • Liquid or grease has seeped behind the control panel and shorted the touch pad
  • The ribbon cable connecting the touch pad to the control board is loose, bent, or corroded
  • A manufacturing defect in the touch pad membrane itself
  • Power surge or electrical interference affecting the control board
  • Excessive heat exposure warping the touch pad or connector

How to fix the F13 error

  1. Power cycle the oven: Turn off the oven at the wall switch or breaker for 5 minutes, then restore power. This clears many temporary F13 faults caused by a momentary glitch.
  2. Inspect the touch pad for stuck buttons: Press each button gently to check for one that feels stuck or doesn’t spring back. Clean around the edges with a soft, slightly damp cloth and dry thoroughly.
  3. Check for spills or residue: Wipe down the entire control panel surface, paying attention to seams and edges where liquid could have seeped in during cleaning or cooking.
  4. Access and reseat the ribbon cable: With power disconnected, remove the control panel cover and check the ribbon connector linking the touch pad to the control board. Unplug and firmly reseat it to rule out a loose connection.
  5. Test with a multimeter (optional): If comfortable doing so, check the touch pad membrane for continuity issues that indicate an internal short.
  6. Replace the touch pad or control board: If the error persists after the steps above, the touch pad membrane or control board itself likely needs replacing. This typically requires a service call or a replacement part matched to your model number.

FAQ

Can I keep using my oven if it shows F13?
You may be able to clear the code temporarily by power cycling, but if it returns repeatedly, the touch pad or its connection needs to be checked before relying on the oven for regular use.

Is F13 dangerous?
No, it’s not a safety hazard like a heating or door lock fault. It affects the control interface, not the oven’s heating elements directly, though a malfunctioning touch pad can make the oven hard to control.

Will resetting the breaker fix F13 permanently?
Sometimes, if the cause was a one-off glitch. But if a button is physically stuck or the ribbon cable is damaged, the error will come back and the part will need replacing or cleaning.