The E68 error on your Frigidaire dryer means the control board has detected a stuck button or a communication fault on the keypad/touchpad panel. It usually means a button is physically stuck or the control panel needs a reset.

Error code E68
Meaning Keypad/touchpad button stuck or control panel communication fault
Severity Medium — dryer may pause mid-cycle or refuse to start until cleared
Time to fix 10–30 minutes
Tools needed Screwdriver (for panel removal), soft cloth, multimeter (optional)

What the E68 error means

Frigidaire dryers use a touchpad or button panel wired to the main control board. The E68 code appears when the board senses that one of the buttons is being pressed continuously, even when no one is touching it, or when the ribbon cable connecting the panel to the board loses signal briefly. This is similar in nature to how other Frigidaire appliances flag sensor faults, such as the Frigidaire EF Error Code on refrigerators, where a component reports a signal outside its normal range.

In most cases this is not a major mechanical failure — it’s either a debris/moisture issue under a button, a worn membrane on the touchpad, or a loose connector behind the control panel.

Common causes

  • A button on the control panel is physically stuck or sticky from spilled liquid, lint, or fabric softener residue
  • Loose or corroded ribbon cable connector between the touchpad and the main control board
  • Moisture trapped behind the control panel from a humid laundry room
  • A failing touchpad membrane that sends a false “pressed” signal
  • Power surge or voltage fluctuation that scrambled the control board’s memory
  • A worn-out main control board that can no longer read the keypad correctly

How to fix the E68 error

  1. Power cycle the dryer — Unplug the dryer or switch off the breaker for 60 seconds. This clears the control board’s memory and often resolves a temporary E68 fault.
  2. Inspect the control panel for stuck buttons — Press each button gently to check if one feels stuck or doesn’t spring back. Wipe the panel with a dry cloth to remove any residue.
  3. Remove the top control panel — With the dryer unplugged, take off the screws securing the console and gently lift it to check the ribbon cable connection to the control board.
  4. Reseat the ribbon cable — Disconnect and firmly reconnect the touchpad cable to the control board, making sure it’s fully seated and not bent or frayed.
  5. Dry out any moisture — If the dryer sits in a damp area, leave the panel open for an hour to air dry before reassembling.
  6. Replace the touchpad or control board — If the error returns after a reset and inspection, the touchpad membrane or control board itself likely needs replacing. This is best done by ordering the exact part number for your model.

FAQ

Can I keep using the dryer with an E68 error showing?
It’s best not to. The dryer may not respond to button presses correctly, which can mean a cycle stops partway through or won’t start at all.

Will unplugging the dryer fix E68 permanently?
Sometimes, if the cause was a temporary glitch. If the error keeps coming back within a few cycles, there’s likely a physical fault with the touchpad or its connector.

Is E68 expensive to repair?
Not usually. A stuck button or loose cable costs nothing to fix yourself. A replacement touchpad or control board typically runs £50–£150 for the part, plus labour if you hire a technician.