The E10 error on your Frigidaire dryer means the control board did not detect enough heat during a drying cycle within the expected time. Check the heating element, thermal fuse, and airflow before assuming the electronics are at fault.

Error code E10
Meaning No heat or insufficient heat detected by the control board during operation
Severity Medium — dryer may still tumble but won’t dry clothes properly
Time to fix 20–45 minutes
Tools needed Multimeter, screwdriver, vacuum or dryer vent brush

What the E10 error means

Frigidaire dryers with electronic controls monitor the temperature inside the drum during a cycle. If the sensors don’t register a rise in heat within a set window of time, the control board flags it as E10. This usually points to a heating element that isn’t working, a tripped safety component, or airflow that’s too restricted for heat to build up properly.

It’s a similar concept to how refrigerator sensor faults get flagged — for reference, see how sensor-related issues show up in the Frigidaire EF Error Code: Causes and Fixes guide, which covers a comparable detection logic on the fridge side.

Common causes

  • Burnt-out heating element (electric models) or faulty igniter (gas models)
  • Blown thermal fuse cutting power to the heater circuit
  • Clogged lint filter or vent restricting airflow so heat can’t build up
  • Faulty thermostat or thermistor sending incorrect temperature readings
  • Loose or corroded wiring connections at the heating circuit
  • Failed control board unable to trigger the heating relay

How to fix the E10 error

  1. Power down and unplug the dryer: Always disconnect power before inspecting or touching internal components.
  2. Check the lint filter and vent: Clean out the lint screen and check the exhaust vent for blockages, as restricted airflow is one of the most common triggers.
  3. Inspect the thermal fuse: Locate the thermal fuse (usually near the exhaust duct) and test it with a multimeter for continuity. Replace if it shows no continuity.
  4. Test the heating element: Use a multimeter to check the heating element for continuity. A reading of infinity means it’s burnt out and needs replacing.
  5. Examine wiring and connectors: Look for loose, burnt, or corroded wires at the heater circuit and reseat or replace as needed.
  6. Reset and run a test cycle: After repairs, plug the dryer back in, run a short cycle, and confirm the error clears and heat is produced.

FAQ

Can I keep using the dryer if it shows E10?
You can run cycles, but clothes likely won’t dry properly since the heating circuit isn’t functioning. It’s best to fix the issue before continuing regular use.

Is E10 the same across all Frigidaire dryer models?
The general meaning — a heat detection failure — is consistent, but the exact wiring layout and part locations vary by model, so check your owner’s manual for specifics.

Do I need a technician to fix E10?
If you’re comfortable using a multimeter and following basic safety steps, many causes like a blown thermal fuse or clogged vent can be fixed yourself. A failed control board typically requires professional replacement.