The 1E error on your LG Washer means there’s a problem with the Hall sensor or pressure sensor system that detects water levels. This error typically prevents the washer from starting or continuing a cycle, and it’s often caused by sensor malfunction, wiring issues, or control board problems.
| Error code | 1E |
|---|---|
| Meaning | Hall sensor or pressure sensor failure |
| Severity | Medium — Washer won’t operate, but no water damage risk |
| Time to fix | 20–60 minutes |
| Tools needed | Multimeter, screwdriver set, needle-nose pliers |
What the 1E error means
The 1E error code indicates a failure in the Hall sensor or pressure sensor circuit, which are critical components that monitor water levels and drum rotation in your LG washer. The Hall sensor detects the motor’s position and speed, while the pressure sensor measures how much water is in the tub. When the control board can’t receive proper signals from these sensors, it triggers the 1E error to prevent potential damage or operational issues.
Common causes
- Faulty Hall sensor on the motor assembly preventing proper speed detection
- Damaged or disconnected wiring harness between sensors and control board
- Defective pressure sensor failing to accurately measure water levels
- Corroded or loose electrical connections at sensor terminals
- Malfunctioning main control board unable to process sensor signals
- Water damage to sensor components from previous leaks or overflow
How to fix the 1E error
- Power cycle the washer — Unplug the washer from the wall outlet for 60 seconds to reset the control board. This clears temporary glitches that may be causing false error readings. Plug it back in and run a test cycle to see if the error returns.
- Inspect the wiring harness — Unplug the washer and remove the back panel. Check all wire connections between the Hall sensor (located on the motor), pressure sensor (near the tub), and the main control board. Look for loose plugs, damaged wires, or signs of corrosion. Reconnect any loose connections and replace damaged wiring.
- Test the Hall sensor — Locate the Hall sensor on the motor assembly. Disconnect the wiring harness and use a multimeter to test for continuity. The sensor should show resistance readings between 150–300 ohms depending on your model. If readings are significantly different or show no continuity, replace the Hall sensor assembly, which typically costs $30–$80.
- Check the pressure sensor — Find the pressure sensor connected to the air tube near the tub. Disconnect the sensor and blow gently through the air tube to ensure it’s not clogged. Test the sensor with a multimeter for proper resistance. Clean or replace the sensor if it’s faulty (typically $25–$60 for a replacement part).
- Examine the control board — If all sensors and wiring check out, inspect the main control board for visible signs of damage such as burn marks, corrosion, or damaged components. A failing control board may need professional replacement, costing $150–$350 including labor.
- Contact a professional technician — If you’ve checked all components and the error persists, the issue may require specialized diagnostic equipment or component-level repair. A professional appliance technician can accurately diagnose sensor circuit problems and perform complex repairs safely.
FAQ
Can I still use my LG washer with the 1E error code?
No, the washer will not operate with the 1E error displayed. This safety feature prevents the machine from running when it cannot properly detect water levels or monitor drum rotation, which could lead to flooding, motor damage, or other mechanical failures.
How much does it cost to repair a 1E error on an LG washer?
DIY repairs typically cost $25–$80 for replacement sensors if you can identify and replace the faulty component yourself. Professional repair services generally charge $150–$350 depending on which part needs replacement and local labor rates. The Hall sensor and pressure sensor are relatively inexpensive parts, but control board replacement is more costly.
Is the 1E error the same as IE on LG washers?
Yes, 1E and IE are the same error code on LG washers. The confusion arises because the digital display can make the number “1” look similar to the letter “I”. Both indicate a Hall sensor or pressure sensor problem requiring the same troubleshooting steps to resolve.