The 26E error on your Samsung Washer means there is a communication failure between the main control board and the motor control board. This error typically requires checking electrical connections and may indicate a wiring or control board issue.

Error code 26E
Meaning Communication error between main control board and motor control board
Severity High — Washer will not operate until resolved
Time to fix 15–45 minutes
Tools needed Multimeter, screwdriver set, flashlight

What the 26E error means

The 26E error code indicates a communication breakdown between the washer’s main control board (PCB) and the motor control board (inverter board). These two components must communicate constantly to coordinate the motor’s operation during wash cycles. When the signal pathway is interrupted due to loose connections, damaged wiring, or a faulty control board, the washer displays this error and stops functioning to prevent potential damage.

Common causes

  • Loose or corroded wire harness connections between control boards
  • Damaged wiring or wire harness due to vibration or wear
  • Faulty main control board (PCB) unable to send signals
  • Defective motor control board (inverter board) not receiving signals
  • Power surge or electrical interference disrupting communication
  • Water damage to control boards or connectors causing short circuits

How to fix the 26E error

  1. Power cycle the washer completely — Unplug the washer from the electrical outlet for at least 2 minutes to reset the control boards. Plug it back in and test if the error clears. This simple reset resolves temporary communication glitches in about 20% of cases.
  2. Inspect wire harness connections — Unplug the washer and remove the top and rear panels to access the control boards. Locate the wire harness connectors between the main control board (usually behind the control panel) and the motor control board (typically at the bottom). Disconnect and reconnect each connector firmly, checking for corrosion, bent pins, or damage.
  3. Check for damaged wiring — Visually inspect all wires running between the two control boards for signs of wear, cuts, pinching, or burn marks. Pay special attention to areas where wires pass through metal edges or near moving parts. Replace any damaged wire harnesses.
  4. Test the main control board — With a multimeter set to voltage mode, verify the main control board is receiving proper power (typically 120V AC). Check that it’s sending output signals to the motor control board (usually 5V DC reference signals). If no output is detected, the main control board likely needs replacement.
  5. Test the motor control board — Inspect the motor control board for visible signs of failure such as burnt components, bulging capacitors, or scorch marks. Use a multimeter to check for continuity in the board’s connections. If the board shows damage or doesn’t respond to signals from the main board, it requires replacement.
  6. Replace faulty control boards — If testing confirms a defective control board, order the correct replacement part using your washer’s model number. Install the new board, ensuring all wire harness connections are secure. Reassemble the washer panels and test a cycle to confirm the error is resolved.

FAQ

Can I continue using my Samsung washer with a 26E error code?
No, you cannot use the washer when the 26E error is displayed. The communication failure prevents the control boards from coordinating motor operations, so the washer will not start any cycles. Attempting to force operation could cause additional damage to electrical components.

How much does it cost to fix a 26E error on a Samsung washer?
If the issue is simply loose connections, the repair costs nothing but your time. A wire harness replacement costs $30–$80 for parts. A main control board costs $150–$250, while a motor control board runs $100–$200. Professional repair service typically charges $200–$400 including parts and labor, depending on which component needs replacement.

Is the 26E error covered under Samsung’s warranty?
If your Samsung washer is still within the manufacturer’s warranty period (typically 1 year for parts and labor, with extended coverage on certain components), the 26E error repair should be covered. Contact Samsung customer service or an authorized service center with your model and serial number to verify warranty status before attempting repairs or purchasing parts.