The E1 error on your Maytag Washer means the control board has detected a communication or sensing fault, most often linked to the F0 code that appears alongside it. Together, F0 E1 usually points to an overload condition or a signal problem between the motor control board and the main control board, and most owners can check the basics themselves before calling a technician.

Error code E1
Meaning Communication or overload fault between the motor control unit and the main control board
Severity Medium — the washer usually stops mid-cycle but the issue is often fixable at home
Time to fix 10–40 minutes
Tools needed None for a basic reset; multimeter for wiring checks

What the F0 E1 error means

The F0 E1 combination on Maytag washers signals that the main control board isn’t receiving a proper response from the motor control board, or that the machine has sensed an unusually heavy or unbalanced load. This is similar in nature to other communication faults such as the Maytag Washer F1 Error Code, where the control board loses track of a component’s status. The washer typically pauses the cycle and displays the code to prevent damage to the motor or drum.

Common causes

  • Overloaded drum causing the motor to draw too much power
  • Loose or damaged wiring harness between the motor control board and main control board
  • Faulty motor control board that isn’t sending the correct signal
  • Worn main control board unable to interpret sensor data correctly
  • Power supply issues, such as voltage fluctuations or a weak connection
  • A stuck or failing drive motor putting extra strain on the system

How to fix the F0 E1 error

  1. Power cycle the washer: Unplug the machine for 60 seconds, or switch off the breaker, then restart it to clear a temporary control board glitch.
  2. Reduce the load size: Remove some laundry if the drum is overloaded and run a smaller wash to see if the code clears.
  3. Inspect the wiring harness: Unplug the washer, remove the rear or console panel, and check the connectors between the motor control board and main board for looseness or corrosion.
  4. Check for balanced loads: Redistribute wet clothing evenly around the drum, especially with bulky items like towels or bedding, then restart the cycle.
  5. Test the motor control board: Use a multimeter to check for continuity and proper voltage output, comparing readings against the service manual specifications.
  6. Replace the faulty board: If the main or motor control board fails testing, replace it with a manufacturer-approved part, similar to the process used for the Maytag Washer F2 Error Code.

FAQ

Can I keep using my washer if it shows F0 E1?
It’s best to stop and address the issue first. Continuing to run cycles can strain the motor or damage the control board further.

Does a power reset always fix F0 E1?
Not always, but it resolves many cases caused by temporary communication glitches. If the code returns after a reset, a wiring or board issue is more likely, much like with the Maytag Washer F3 Error Code.

Is this error expensive to repair?
A basic reset or load adjustment costs nothing. If a control board replacement is needed, parts and labor can range from moderate to fairly high depending on your model, similar to repairs for the Maytag Washer F5 Error Code.