The F9E0 error on your Maytag Washer means the control board has detected that the tub is not draining within the expected time, or it has sensed an overflow condition. This is often called a “long drain” error. Checking the drain hose and pump filter usually resolves it.

Error code F9E0
Meaning Long drain or overflow — water is not leaving the tub fast enough
Severity Medium — the washer will not complete a cycle until this is fixed
Time to fix 15–40 minutes
Tools needed Towels, a shallow pan, pliers, flashlight

What the F9E0 error means

Maytag washers monitor how quickly water leaves the tub during the drain phase of a cycle. If the water level sensor (pressure switch) doesn’t detect a drop within the expected window, the control board flags F9E0 and stops the cycle to prevent overflow damage. It’s a safety feature rather than a sign the machine is broken beyond repair.

In most cases the cause is something physical blocking water flow — a clogged filter, kinked hose, or trapped item — rather than an electronic fault. It shares similarities with drain-related issues seen in other Maytag fault codes, such as the Maytag Washer F2 Error Code.

Common causes

  • Clogged drain pump filter with lint, coins, or debris
  • Kinked, crushed, or blocked drain hose
  • Drain hose positioned too high or looped incorrectly, causing siphoning issues
  • Faulty or failing drain pump motor
  • A small item of clothing stuck in the pump impeller
  • Blocked or slow household drain pipe the washer empties into

How to fix the F9E0 error

  1. Power down and unplug the washer — Cut power at the outlet before opening any access panel to avoid electric shock.
  2. Locate and clean the drain pump filter — Open the small access panel at the front base of the machine, place a shallow pan underneath, and remove the filter to clear lint, coins, or debris.
  3. Inspect the drain hose — Check behind the washer for kinks, crushing, or blockages, and straighten or replace the hose if needed.
  4. Check the hose height and drain standpipe — Make sure the hose isn’t inserted too far into the standpipe and that the standpipe itself isn’t blocked.
  5. Restart a drain/spin cycle — Plug the washer back in and run a drain or spin-only cycle to see if the error clears.
  6. Test the drain pump — If water still won’t drain, the pump motor may need testing with a multimeter or replacing by a technician.

FAQ

Can I run another cycle after clearing F9E0?
Yes. Once you’ve cleared the filter and hose and the error code has reset, start a new wash or spin cycle to confirm the fix worked.

Is F9E0 dangerous to ignore?
It won’t damage the washer immediately, but ignoring it risks water overflow onto your floor if the machine attempts to fill again with a blocked drain.

Why does F9E0 keep coming back after I clean the filter?
This usually points to a failing drain pump or a blockage further down the household drain line — both are worth checking if the filter is already clear, similar to persistent issues seen with the Maytag Washer F5 Error Code.