The F5E0 error on your Maytag Washer means the control board has detected a problem with the door lock (lid lock) circuit — usually that it cannot confirm the door is locked or unlocked when it should be. This is often fixable at home by checking the door strike, latch, and wiring before replacing any parts.

Error code F5E0
Meaning Door/lid lock switch failure or the control cannot verify the door lock status
Severity Medium — washer won’t start or complete a cycle until resolved
Time to fix 15–45 minutes
Tools needed Multimeter, screwdriver (Phillips and flathead)

What the F5E0 error means

Maytag washers use a door lock mechanism with a switch that tells the control board whether the door is securely closed and locked. The F5E0 code appears when the board sends a signal to lock or unlock the door but doesn’t get the expected response back from the switch. This can be a genuine lock failure, a wiring fault, or sometimes a false alarm from a stuck door striker or debris in the latch.

Common causes

  • Faulty door lock/switch assembly that has worn out or failed
  • Door striker misaligned or broken, preventing a full latch
  • Loose, corroded, or damaged wiring connector at the lock assembly
  • Debris, detergent buildup, or a foreign object blocking the latch
  • Control board fault (less common, but possible after ruling out mechanical issues)
  • Door not closed firmly enough before the cycle starts

How to fix the F5E0 error

  1. Power cycle the washer — Unplug it for 1 minute, then plug it back in. This clears temporary faults and lets the control board re-check the lock circuit.
  2. Inspect the door and striker — Open and close the door firmly, checking that the striker pin lines up with the latch and isn’t bent, loose, or broken.
  3. Clean the latch area — Remove any lint, detergent residue, or debris around the door strike and lock mechanism that could stop it from fully engaging.
  4. Test the lock switch — With the machine unplugged, access the door lock assembly and use a multimeter to check continuity across the switch terminals; replace if it fails continuity tests.
  5. Check the wiring harness — Look for loose, corroded, or disconnected wires at the door lock connector and reseat or repair as needed.
  6. Replace the door lock assembly — If the switch tests faulty or the error persists after mechanical checks, install a new OEM door lock assembly matched to your model.

If you’re also seeing other fault codes on your machine, it helps to compare them — see our guides on the Maytag Washer F1 Error Code: Causes and Fixes, the Maytag Washer F2 Error Code: Causes and Fixes, and the closely related Maytag Washer F5 Error Code: Causes and Fixes for more troubleshooting steps. If the door lock issue seems linked to a broader control fault, the Maytag Washer F3 Error Code: Causes and Fixes guide is also worth checking.

FAQ

Can I still run a cycle if my washer shows F5E0?
No. The washer won’t start or complete a cycle until the door lock fault is cleared, since it’s a safety mechanism to prevent the door opening mid-cycle.

Do I need a professional to fix this?
Not always. Many cases are caused by a misaligned striker or dirty latch, which you can fix yourself. Replacing the lock assembly is also a straightforward DIY job with basic tools.

How much does a replacement door lock assembly cost?
Parts typically range from £20–£50 (US $25–$65) depending on your model, plus labor if you hire a technician.