The END display on your GE Dishwasher means the wash cycle has finished normally. In most cases this is not an error at all, but if END is flashing, staying lit for hours, or appearing with a beep pattern that won’t stop, it usually points to a stuck door latch, a control board glitch, or a cycle that didn’t fully drain.

Error code END
Meaning Cycle complete indicator; flashing or persistent END can signal a latch, drain, or control fault
Severity Low — usually just a status light, but persistent flashing can mean a real fault
Time to fix 5–20 minutes
Tools needed None, or a screwdriver if checking the door latch

What the END error means

On most GE dishwasher models, END is simply the display telling you the wash and dry cycle has finished — it’s meant to be a helpful signal, not a fault code. It typically lights up steadily for a few minutes before the display goes dark on its own.

Problems arise when END flashes repeatedly, refuses to clear even after you open and close the door, or shows up alongside beeping that continues long after the cycle should have ended. That behavior usually means the dishwasher’s control board thinks the cycle finished but a component (like the door latch or drain pump) hasn’t confirmed it properly.

Common causes

  • Normal cycle completion — no fault, the display is working as intended
  • Door not latched securely, so the control board can’t confirm the cycle closed out properly
  • Standing water left in the tub after a weak or incomplete drain cycle
  • Control board losing sync after a power flicker or brief outage mid-cycle
  • A stuck button on the control panel keeping the display from resetting
  • Blocked or kinked drain hose preventing the machine from fully finishing its final drain

How to fix the END error

  1. Wait it out first. If END just lit up, give it 5–10 minutes. Most GE dishwashers clear this automatically once the cycle is truly done.
  2. Open and firmly close the door. This forces the control board to re-check the door latch switch and often clears a stuck display.
  3. Check for standing water. Open the door and look in the tub. If water is pooled at the bottom, the drain didn’t finish — check the drain hose for kinks and clear the filter of food debris.
  4. Power cycle the dishwasher. Turn off power at the breaker for 60 seconds, then restore it. This resets the control board and clears most display glitches.
  5. Inspect the door latch assembly. If the door doesn’t feel like it clicks solidly shut, the latch switch may be worn or misaligned and could need replacing.
  6. Call a technician if it repeats. If END keeps flashing after a reset and the drain and latch both check out, the control board itself may be faulty.

FAQ

Is END actually an error code on GE dishwashers?
No, in most cases it’s simply the normal “cycle finished” indicator. It only signals a problem if it flashes continuously or won’t clear.

Why won’t the END display turn off?
This is usually caused by a door that isn’t fully latched or leftover water in the tub from an incomplete drain. Closing the door firmly and checking the drain filter often solves it.

Should I unplug my dishwasher to fix this?
Yes, cutting power at the breaker for about a minute is a safe first step and resolves most control board glitches without needing a repair call.