The BOOT error on your Amazon Fire means the device is stuck repeatedly restarting on the Amazon or Fire TV logo screen without ever reaching the home screen. This is commonly called a boot loop, and it usually points to a software or storage fault rather than a hardware failure. In most cases it can be fixed at home without needing a replacement.

Error code BOOT
Meaning The Fire TV device fails to complete its startup sequence and cycles the logo screen repeatedly
Severity Medium — annoying but usually fixable without professional repair
Time to fix 10–30 minutes
Tools needed None (occasionally a USB cable or paperclip for factory reset)

What the BOOT error means

When a Fire TV device or Fire TV Stick gets stuck in a boot loop, it means the firmware isn’t loading correctly during startup. The device powers on, shows the Amazon or Fire TV logo, then restarts before finishing the boot process, and this cycle repeats indefinitely. It’s similar to other startup failures like those covered in the Amazon Fire 5 Error Code: Causes and Fixes guide, where the device can’t progress past its initial checks.

This usually happens after a failed software update, corrupted cache data, or insufficient power reaching the device. It’s rarely caused by a broken screen or physical damage since Fire TV devices connect through your TV’s HDMI port.

Common causes

  • Interrupted or failed firmware update
  • Corrupted system cache or storage partition
  • Insufficient power from a weak USB port or faulty power adapter
  • Overheating from poor ventilation behind the TV
  • A recently installed app or channel conflicting with the system
  • Ageing internal storage on older Fire TV Stick models

How to fix the BOOT error

  1. Check the power supply first. Unplug the Fire TV device and use the original Amazon power adapter plugged directly into a wall outlet, not a TV’s USB port, since low power is a leading cause of boot loops.
  2. Unplug and wait 60 seconds. Disconnect power completely, wait a full minute, then plug it back in. This clears temporary memory and lets the device attempt a clean boot.
  3. Try a factory reset using the remote. If the Fire TV remote responds, hold the Back and Right buttons together for 10 seconds to trigger a reset, which clears corrupted settings causing the loop.
  4. Use the physical reset method. For devices with a reset pinhole, hold it down for 10–15 seconds with a paperclip while the device is powered on, then release and let it restart.
  5. Improve ventilation and cool the device down. Move the Fire TV stick or box away from other hot electronics and let it sit unplugged for 10 minutes before retrying, since overheating can trigger repeated restart cycles.
  6. Contact Amazon support if the loop continues. If none of these steps work after multiple attempts, the internal storage may have failed and the device will likely need replacing under warranty.

FAQ

Why does my Fire TV Stick keep restarting on the logo screen?
This is almost always caused by a power issue, a failed update, or corrupted storage. Starting with the power adapter check resolves most cases quickly.

Will a factory reset delete my apps and settings?
Yes, a factory reset erases all installed apps, sign-in details, and preferences, returning the device to its original out-of-box state. You’ll need to set it up again afterward.

How long should I leave the Fire TV unplugged before trying again?
60 seconds is usually enough to clear temporary memory, but if you suspect overheating, leaving it unplugged for 10 minutes gives it time to cool down properly.